cart icon  Cart 0 USD
call us icon Login
search by vehicle search vehicle icon
GO
close
Cart 0
Apply Promo Code
Subtotal
$0.00 USD
Order total:
$0.00 USD

Note:
Displayed Shipping Cost is estimate here. Final costs will be calculated at Checkout for actual Shipping Address.
Haltech Usage Policy:
In many states, it is unlawful to tamper with your vehicle's emissions equipment. Haltech products are designed and sold for sanctioned off-road/competition non-emissions controlled vehicles only and may never be used on a public road or highway. Using Haltech products for street/road use on public roads or highways is prohibited by law unless a specific regulatory exemption exists (more information can be found on the SEMA Action Network website www.semasan.com/emissions for state by state details in the USA). It is the responsibility of the installer and/or user of this product to ensure compliance with all applicable local and federal laws and regulations. Please check with your local vehicle authority before purchasing, using or installing any Haltech product.

How to crimp sensor connectors

Pressure, Temperature, MAP, or Flex Fuel – sensors are an integral part of any engine management system and getting them properly connected is super important. In this step-by-step guide, the ever-patient Dave shows us how correctly crimp all Haltech push-to-seat sensor connectors.

Covered in this video are GM-style, push-to-seat connectors for Temp, Pressure, MAP, Bosch Pressure/Temp, Deutch, Ignition Coil, and EV1 style sensors.


Related videos: